Backup the following info if needed: There is no software for the OS Version you selected. I followed the directions from the book and on the software cd. When to calibrate is a commonly asked question. Last edited by teckat; at Row three displays the default calibration with no simulation. Calibration compares the current performance of the print engine with its optimum performance.
|Date Added:||5 December 2008|
|File Size:||33.32 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
imagePASS-B1 – Support – Download drivers, software and manuals – Canon Middle East
To install your lmagepass click on the name of the downloaded file. Now click Apply to accept the calibration. You may wish at this time to make sure that no valuable data resides on the USB flash drive.
Power on the print engine and allow the system to boot up. Place the Color Cal Page face down over the grayscale strip.
At the security warning screen, click Install. Need to upgrade driver i guess, but i think its updated.
Color Cal offers the option of calibrating the device scanner in the imagdpass there has been a change to the scanner. Again Imagepazs went step by step from the Installation and Service Guide with no luck. Now click the Customize button Wait approximately 5 minutes until the Select Language screen appears.
This measurement page reflects the current performance of the print engine. Select to print 1 page and then click Print.
Ask the network administrator to restore the non-resident fonts and FreeForm masters that were archived earlier. Actual prices are determined by individual dealers and may vary.
If your equipment is not listed, click Add to initiate a search for all networked Fiery servers. Click imagelass the title for more information. There are no Recommended Downloads available. The default password is Fiery.
Row three displays the default calibration with no simulation. Imageepass is no firmware for the OS version you selected. I turn dip swith on on fiery and try but no luck. At the Select Language screen, select the language that you want to use.
Canon Imagepass-b1 for Imagerunner Advance – 3394B003AA
In addition to evaluating the Comparison Page, you may also view the results of your calibration in Step 6 – View Measurements. The graph displays the tone curves of measured density values plotted against imagepaws or target density values for each color channel a.
There is no software for the OS Version you selected. After the installation is complete, the application will automatically launch.
I followed the directions from the book and on the software cd. Enter the password for the Fiery. Click the icon next to each color channel on the right hand side of the Measurement vs. In the top right hand corner of the Calibrator window, select Expert Mode to open the window and display the six-step calibration procedure 6. If the drive is still attached when the PC starts up or reboots, system corruption may result.